snow blower, shear pin broke, but part is still stuck, top & bottom broke off, tried to hammer piece out,no go

Comments

2 Responses to “snow blower, shear pin broke, but part is still stuck, top & bottom broke off, tried to hammer piece out,no go”
  1. tlindsey3417@verizon.net says:
    June 26, 2009 at 9:59 pm

    here is the problem The shear pin did its job. It can not be driven out because the pin is now off set. thus you are driving it against the inner shaft without it being lines up. look for marks on the shaft and driven mechanism, align and gentle begin to pat with a hardened drift. exercise care. You may be able to contact the manifacturer to check for correct alignment . Good luck and take care of your family. Respectfully Thomas tlindsey3417 at verizon.net

  2. rugbyplayer1988 says:
    June 26, 2009 at 9:59 pm

    Drill a hole in the center of it and then take a tap and hammer it into it and yank it out.


 
Powered by WordPress Lab