PLEASE HELP!! I put the wrong oil mix in my TORO S200 SNOWBLOWER?

what should i do? i used one of those multiple oils and the gas. please help

Comments

5 Responses to “PLEASE HELP!! I put the wrong oil mix in my TORO S200 SNOWBLOWER?”
  1. justpoor says:
    July 25, 2009 at 1:22 am

    Remove the feeder hose, and drain the tank. Rinse tank with gas, then start all over. You might have to pull on cord quite a few times in order to get the bad stuff through, also take out the spark plug and clean it off after you think the bad is gone.

  2. g g says:
    July 25, 2009 at 1:22 am

    there has to be a drain plug somewhere. replace with the right oil. it might smoke a little but should be alright.

  3. Ridgerunner says:
    July 25, 2009 at 1:22 am

    I’d just get what I could out of the tank and then put in right mixture, Don’t think you are going to do any damage with just a little running with your mixture. Best of luck

  4. Troy T says:
    July 25, 2009 at 1:22 am

    Just run it, It will be fine.

  5. Pat B says:
    July 25, 2009 at 1:22 am

    as long as you have the right ratio of gas to oil it will be fine I have used regular motor oil when I was out of 2 cycle oil and didn’t want to go the store several times and have never had a problem.

Leave An Answer

Tell us what you're thinking about this question...
and oh, if you want a pic to show with your comment, go get a gravatar!